Схема внутренних возбуждений в квантовой капле
Аннотация
Маленькие капли сталкиваются квазиупруго, проявляя солитонное поведение. С другой стороны, крупные сталкивающиеся капли могут сливаться или фрагментироваться в зависимости от их относительной скорости. Установлено, что частота дышащего возбужденного состояния капель, предсказанная динамическим вариационным приближением, основанным на гауссовском анзаце, находится в хорошем согласии с численными результатами
Ключевые слова
Гауссиан, солитон, поверхностное натяжение
Diagram of internal excitations in a quantum droplet
S.M.Usanov 1, SH.M. Usanov 2
1Kimyo International University in Tashkent, 156 Usman Nasyr Str., 100121, Tashkent, Uzbekistan
2Tashkent Institute of Irrigation and Agricultural Mechanization Enginees, National Research University
Annatatsiya: Small droplets collide quasi-elastically, featuring the soliton-like behavior. On the other hand, large colliding droplets may merge or suffer fragmentation, depending on their relative velocity. The frequency of a breathing excited state of droplets, as predicted by the dynamical variational approximation based on the Gaussian ansatz, is found to be in good agreement with numerical results.
Keywords: Gaussian, soliton, surface tension
The stability diagram for the excited droplet in the plane of (N,k) is displayed in Fig. 1, 2, [2-5]
(1)
We demonstrate below that
(2)
determines a critical number of particles separating two different physical regimes.
Thus, rescaling
t = t0t', x = x0x', ψ = ψ0ψ', (3)
casts Eq. (1) in an equation without free coefficients (where the primes are omitted):
(4)
in which symbols correspond to values kc extracted from systematic simulations of Eq. (4), according to the procedure outlined in subsubsection IIIB2 [6-10]. The droplet remains undivided

Figure 1: (Color online) The frequency, ω (the left axis), and damping ratio, ζ (right axis) of oscillations following the application of the density modulation to the droplet, as per Eq. (2), for N = 0.1. The critical value of wavenumber, kc, above which the perturbed droplet splits, is obtained by fitting the frequency in the stable region to . The fit is shown by the solid black line. The dashed line shows the frequency of the breathing mode, , from Fig.
at k < kc. It is seen that the strongest stability corresponds to N ≈ 1. The stability-threshold line may be interpreted in terms of energy considerations, by comparing the collisional kinetic energy [12] associated with the imposed wavenumber, Ekin = Nħ2k2/(2m), and the surface energy, Es, see Eq. (5).
(5)
for N−1 → 0. The coefficients in Eq. define the volume, surface and curvature tension, respectively. The surface tension τ is related to as , where the unit-volume radius r0 is defined by condition .
In the 1D system, the expansion parameter is N−1, instead of N−1/3 in Eq. (5), and the corresponding coefficients can be obtained analytically. The bulk energy density is
Ev = −2/9, and the surface-energy coefficient is Es = 16/(27e2). In one dimension, the “surface” is reduced to two points, hence its size is independent of the size of the droplet. The respective surface tension is
(6)
ψ(x,t = 0) = ψe(x)cos(kx) , (7)
The ratio of the two energies is known as the (modified) Weber number [13, 14]. Curved lines in Fig. 2 correspond to We = 1, 2, and 3. We find that, for N ≳ 4, the classical prediction based on a fixed value of the Weber number explains the stability diagram reasonably well.
(8)

Комментарии